Traditional Muzzleloading on the Cheap

Member’s General Interest => Where can I get it? => Topic started by: Ripmyfly on August 29, 2009

Title: Flinter Pistol
Post by: Ripmyfly on August 29, 2009
Am I missing something or does no one make a reasonable priced flintlock pistol? Any help would be appreciated!
Title: Re: Flinter Pistol
Post by: david32cal on August 29, 2009
i think Pedersoli and Traditions are the only production companys that make a flintlock pistol,and i would'nt call either one reasonably priced.
Title: Re: Flinter Pistol
Post by: tom h on August 29, 2009
what is a reasonable price ?
Title: Re: Flinter Pistol
Post by: Ripmyfly on August 30, 2009
Good question Tom. I guess that's subjective. Since Ive lost my job & broke my answer will be lower than perhaps it should be. Single shot percussion can be found in the 150-200 range... so add 50 bucks for cost of lock. Again, I am not wise in this area at all.
Title: Re: Flinter Pistol
Post by: tom h on August 30, 2009
www.gunbroker.com is a good place to start
Title: Re: Flinter Pistol
Post by: Hanshi on August 30, 2009
You really don't want a "cheap" flint pistol.  Trust me.  chrrs
Title: Re: Flinter Pistol
Post by: Ripmyfly on September 03, 2009
Thanks guys! In your opion is the Lyman flinter pistol made as well as the GPR?
Title: Re: Flinter Pistol
Post by: halfstock on September 04, 2009
Hey Rip far as I know there aint no Lyman flint pistol. strpot bunkr
Halfstock
Title: Re: Flinter Pistol
Post by: tedbudd on September 04, 2009
navy arms flinter is nice I bought 2 and have been happy..also check dixie gun works maybe
Title: Re: Flinter Pistol
Post by: NW Wildman on September 05, 2009
Here some now I dont know if theyll shot http://www.middlesexvillagetrading.com/NEWpistol.shtml hntr
Title: Re: Flinter Pistol
Post by: Spitunia on September 06, 2009
You don't have to put up with pistols that are designed for mediocre performance, mass production and enhanced profit margins. Have it built to fit you.
Title: Re: Flinter Pistol
Post by: Ripmyfly on September 06, 2009
Thanks for all the info guys! I think I will wait & buy the parts & make one myself.